Grove Cable Pigtail - 2mm pitch 100mm long

This 100mm Grove to Bare Wire Cable provides a simple way to connect Grove boards and breakouts to custom wiring, with four colour-coded bare wires for power, ground and signals.

If you'd like to make a connection to a board or breakout with Seeed Grove connection, this 100mm long 4-wire cable is fitted with a Grove connector and four bare wires.

Please note: You will have to watch for voltages on the power/signal pin when using 3V-only sensors, because Grove boards that are 5V logic like many Arduino UNO-compatibles.

The colours are:

• Black for GND
  
• Red for V+ - Can be 3V or 5V power depending on the microcontroller board!
  
• Blue for SDA
  
• Yellow for SCL
  

Note these are not JST cables, and won't fit in JST PH sockets!

Features

• 100mm long 4-wire Grove connector cable
• One end fitted with Grove connector, opposite end with four bare wires
• Colour-coded wires: Black (GND), Red (V+), Blue (SDA), Yellow (SCL)
• Compatible with Grove boards and breakouts
• Supports 3V or 5V power depending on microcontroller board
• Voltage compatibility check required for 3V-only sensors with 5V logic boards
• Not compatible with JST PH sockets

Resources

• Diagram

Package Contents

• 1x Grove Cable Pigtail - 2mm pitch 100mm long

Not compatible with JST PH sockets