Adafruit DRV8871 DC Motor Driver Breakout Board - 3.6A Max

The Adafruit DRV8871 Motor Driver Breakout Board provides simple control of brushed DC motors, handling 6.5–45V motor power with up to 3.6A peak current, PWM control and adjustable current limiting.

Crank up your robotics with powerful Adafruit DRV8871 motor driver breakout board. This motor driver has a lot of great specs that make it useful for a wide variety of mechatronics. In particular, the simple resistor-set current limiting and auto-magic PWM support make it super easy to use with just about any brushed DC motor.

Check out the specs for the DRV8871:

• 6.5V to 45V motor power voltage
  
• Up to 5.5V logic level on IN pins
  
• 565mΩ Typical RDS(on) (high + low)
  
• 3.6A peak current
  
• PWM control
  
• Current limiting/regulation without an inline sense resistor
  
• Undervoltage lockout
  
• Overcurrent protection
  
• Thermal shutdown
  

Using it is super simple. Connect your motor to the OUT terminal block. Power the board with 6.5-45VDC power on VMotor and provide the H-bridge input control on IN1 and IN2. You can even PWM the inputs and the driver chip will do the right thing.

You can set the current limiting with an external resistor Rlim. We solder in a 30K resistor by default for a ~2A current limit, however you can remove this resistor and/or solder a resistor over it to change the resistance and change the limit.

Each order comes with one fully assembled and tested motor driver breakout with two pre-soldered 2-pin terminal blocks and a small strip of header. Some light soldering is required to attach the header, but it's a simple task that can be done with basic soldering equipment.

Breadboard, wheel, cables, and Metro not included. 

Features

• Motor power voltage: 6.5V to 45V DC
• Logic level: up to 5.5V on IN pins
• 565mΩ typical RDS(on) (high + low)
• Peak current: 3.6A
• PWM control support
• Current limiting/regulation without inline sense resistor
• Undervoltage lockout protection
• Overcurrent protection
• Thermal shutdown protection
• Fully assembled and tested
• Includes two pre-soldered 2-pin terminal blocks
• Includes header strip (requires basic soldering)
• Adjustable current limit via external resistor (default 30K for ~2A limit)
• Compatible with brushed DC motors

Revision History

• As of February 12, 2024 We added two pre-soldered terminal blocks.
  
• As of August 22, 2023 we've updated this PCB with Adafruit Pinguin to make a lovely and legible silkscreen - you may get the new PCB or the older version with vector fonts - both are identical other than the fancy silkscreen.

Resources

• Tutorial/EagleCAD/Fritzing documents
• DRV8871 Datasheet

Package Contents

• 1x Adafruit DRV8871 DC Motor Driver Breakout Board - 3.6A Max
• 1x Header strip

Breadboard, wheel, cables, and Metro not included.